This is a DIY combination of motor, bracket, B10 drill chuck，and 20A PWM speed controller, it can be used with a saw blade to become a mini saw.
Modle: 775 Motor
The Specifications of the motor:
Rated Voltage: DC 12V, Unloaded Speed: 10000RPM, Load Speed: 8800RPM.
Rated Voltage: DC 24V, Unloaded Speed: 20000RPM, Load Speed: 17600RPM.
Starting current: 4-5A;
Motor Body Diameter: 42mm ;
Motor Body Length: 66.5mm;
Shaft Length: 16mm;
Shaft Diameter: 5mm
The specification of the speed controller:
Input Voltage: DC 10V-DC 60V (Ultra wide working voltage);
Output voltage: linear under load;
Control Power: 0.01-1200W;
Rated Current: 10A;
Max Current: 20A (Long-term use of 10A, 450W or less, pay attention to keep the module free of heat dissipation conditions.);
PWM Duty Cycle: 0%-100%;
PWM Frequency: 25Khz;
Product Size(L x W x H): 77*45*28mm;
The Specification of the Bracket:
Mounting hole diameter: 4mm
Thickness of bracket: 3mm
Application:Hand tools,garden tools, power tools,shredder, sprayer, small cutting machine, small table saw for cutting/polishing.
1 x DC Motor,1 x PWM speed controller,1 x Bracket,1 x B10 Drill Chuck,2 x Screws,2 x Matching Hardware Tools
1.Please do not connect AC power directly(Such as:110V AC),the input volt of this controller should be DC 9V-60V,otherwise it will be burned out.
2.Make sure the positive and negative connections are correct before powering on the motor speed controller, it will be damaged if connect the supply voltage with wrong polarity.
3.There is a slight discrepancy in measurements, please check before ordering!!
Lifetime technical guidance support! You are welcome to share your usage process with us at any time.
1 year warranty (free exchange)